Eastey ET1608-30, Руководство пользователя

Страница: 29 / 55

Maintenance 29
Note: Do not rest blower housing on blower wheel! Blower wheel will not work if bent or
out of balance.
Blower wheel replacement
Shut off power to the machine. Refer to Blower motor replacement instructions above.
Placement of upper wear rails
Shut off power to the machine, move the conveyor by hand if necessary to gain access.
Remove the #10-32 screw on the idler end. Replace parts in the same manner in which
they were disassembled.
Chamber cooling fan motor replacement
Shut off power to the machine. Remove the top lid of the hood. Disconnect the wires.
Remove four (4) ¼-20 screws which hold the cooling fan motor in place. Take the motor
out of the machine, replace with the new motor, and reassemble with four (4) ¼-20
screws removed earlier. Reconnect wires to new cooling fan motor.
Wire Belt Repair Splicing
Caution! Disconnect main power to the conveyor before attempting to
repair or adjust belt.
Before you begin splicing

Release all belt tensioning mechanisms

If installing a new belt, thread the belt onto the conveyor
-
Check to be sure that the smooth side is “up”
- Check to be sure that the edge loops curve back in the direction opposite the
direction of belt travel
- Remove a strand or two from the new belt to keep in reserve to splice the belt or
in case it may be needed to repair the belt in the future
- Tie both ends of the belt together with cord, twine, or wire ties

If repairing a belt
- Tie two undamaged strands at the end to be spliced together with cord, twine, or
wire ties
- Cut out the damaged wire(s) with a wire cutters
— pick out and dispose of wire
pieces immediately
Important! If a belt has damage in more than one place or if the belt has
been previously repaired, do not try to repair it.
Install a new belt .
Also, never save used belting to use for repairs because it has
already been weakened by use. Purchase several extra feet of
new belting to use exclusively for repairs.