Wireless Energy Demonstration Kit
May 2012, Rev -
− 20 −
http://www.EasternVoltageResearch.com
Wireless Energy Demonstration Kit
3. If your wireless coil is connected as shown above, then you are ready for test.
Begin by placing your wireless demonstration coil approx. 3 feet from your Class-
E resonator coil. Apply power to the Class-E Resonator coil and your wireless
demonstration coil should begin to illuminate.
4. Move your wireless demonstration coil to different locations, closer and
farther, and see how the LEDs get brighter and dimmer. When moving the wire
demonstration coil, be sure to grasp the coil by the primary coil form. Do not
touch any portion of the secondary coil.
NEVER touch the secondary coil of the wireless demonstration unit while your
Class-E Audio Modulator is operating. If you have to move the wireless
demonstration unit, grasp it by the base of the primary coil form. Otherwise, you
may receive a small burn from the high voltage present on the secondary coil.
To increase the longevity of your kit, we recommend not positioning the wireless
demonstration kit closer than 1 ft. to the Class-E Tesla Resonator. Doing so may
couple excessive energy into the wireless demonstration PCB board and overvoltage
some of the devices on the board.
Congratulations! Your Wireless Energy Demonstration Kit is now completed and
operational.
