Wireless Energy Demonstration Kit
May 2012, Rev -
− 15 −
http://www.EasternVoltageResearch.com
Wireless Energy Demonstration Kit
secondary RF ground to the included ground wire and PCB board.
Begin
winding the secondary at the locations shown in the figure below. Continue
winding the secondary, ensuring each wind is neat and tightly together with
adjacent windings, for the entire length as indicated in the figure below. Adding
masking tape every inch or so will ensure the windings don’t unwind and also
allows you to take rests if needed. Once you are completed, tape off the end of
the winding, and finally add a few extra turns. Do not coat the secondary coil at
this time. You will first need to tune the coil for proper operation and may need
to adjust the number of turns.
