EASTAR UHP-1000 SERIES SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.3
(SW VERSION 2.2.9)
© ROMANTIS 2010
51
www.romantis.com
Figure 24 Router reboot procedure
Reboot procedure control commands write the configuration not in the configuration profile
but in a separate place. Changes come into force immediately after the command is entered
and no save operation is required.
boot main 0-3 0-1 - Main boot profile FLASH_BANK(0-auto) CONF_BANK
The command selects the main bank for
reboot
. The first parameter for the bank is SW, the second
–
for the
configuration profile.
boot temp 0-3 0-1 - Temp boot profile FLASH_BANK(0-none) CONF_BANK
Same for the bank with temporary SW.
boot fallback timeout 1-10000 - Temp image auto fallback period (min)
Delay in minutes prior to possible
reboot
back to the main bank.
boot fallback reason uptime|link-up - Auto fallback reason
After the delay,
reboot
occurs either in any case or if the station failed to establish communication with Hub.
boot fallback stop - Abandon auto fallback
Abandons automatic reboot. Manual reboot will in any case take place to the main bank.
Reboot procedure settings can be displayed using «show boot» command:
UHP# sh bo
Main: Flash bank - AUTO Config profile - 0
Temp: Flash bank - NONE Config profile - 0
Fallback delay: 5 Fallback reason: Link-up
Example of working with fallback.
Old SW in bank 1, new one is written down in bank 3
bo ma 1
- main bank 1
bo te 3
- temporary bank 3
re
- reboot (bank 3 will be rebooted)
If you managed to log in the router, issue the "boot fallb stop‖ command, counting until
RESET
Autoselect
of bank
Main=0, Temp=0
RESET
Select
Main
Main>0, Temp=0
RESET
Select
Temp
Temp>0
Delay
Reset
No HUB
connection
AutoRestart
Select
Main
Software launch
Software launch
