EAS Electric EMD12I, Руководство пользователя

Страница: 51 / 80

48
1. PRIOR USING FOR THE FIRST TIME
Before using for the first time:
1. Set the water softener.
2. Add 1.5kg dishwasher salt and then full fill the salt container with water.
3. Fill the rinse aid dispenser.
4. Fill in detergent.
4.1 Water softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water,
which would have a detrimental or adverse effect on the operation of the
appliance.
The higher the content of these minerals and salts, the harder you water is.
The softener should be adjusted according to the hardness of the water in your
area, your local Water Authority can advise you on the hardness of the water in
your area.
ADJUSTING SALT CONSUMPTION
The dishwasher is designed to allow for adjustment in the amount of salt
consumed based on the hardness of the water used. This is intended to
optimize and customize the level of salt consumption.
1. Open the door, switch on the appliance.
2. Press the program button for more than 5 seconds to start the water
softener set model within 60 seconds after the appliance was switched
on (the salt and rinse aid warning lights will be on periodically when it
gets in the set model).
3. Press the program button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1>H2>H3>H4>H5>H6.
4. Press the power button to end the set-up model.
1. Upper basket 5. Dispenser 9. Inlet pipe connector
2. Inner pipe 6. Culp shelf 10. Drain pipe
3. Lower basket 7. Spray arms
4. Salt container 8. Filter assembly
V.1