Assembly and Operation Instructions
2600A-PLUS_M52215_July2021
PAGE 3
PAGE
Step 5:
Slide the
axle
(coast wheel side first) through
the right side
lower handle
and into the
gearbox
(with
the arrow facing the FRONT). You will need to rotate the
axle to engage with the gearbox, then through the left
side lower handle.
Next, install the
axle bearings
over the axle and into both
lower handles
as shown to the right.
NOTE
: You need to align the tab on the
bearings
and
the notches in the
lower handles
. (See right.)
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
Step 6:
Install the
drive wheel
onto the axle and align
it with the cotter pin hole nearest to the
lower handle
(as
shown). Insert the
1 ¾”
cotter pin through the wheel and
axle. Bend with pliers to prevent pin from falling out.
Step 7:
Install the
coast wheel
onto the axle fully,
then add the
1”
large flat washer
. Insert the
¾”
cotter
pin through the axle (not through the wheel). Bend with
pliers to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS
Step 8:
Select (2)
¼” x 1 1/2”
bolts and (2)
¼”
-
20
nylon lock nuts
to complete this step.
Notice that the circular
handle shaft
has two sets
of holes in both ends. The holes that are closest
to the end of the shaft is the top. Slide the handle
shaft inbetween the handles and secure with (2)
¼”
-20 bolts
and
nylon
lock
nuts
.
Step 9:
Insert (2)
¼”
-20 x 1 ½
bolts through
the
gauge
and
linkage assembly
, then through
the
upper
handle
, and
handle
shaft
. Secure with
two
¼”
-20 nylon lock nuts
.
1
1
/4 - 20 x 1-
1/2” Bolt
Handle Shaft
/4 - 20 Lock-nut
