Frame
Upper handles
Gauge &
Linkage
Assembly
Handle Shaft
Lower
Handles
Wheels
Impeller
Gearbox
Axle
Control Rod
Frame Braces
1.
Remove and identify all loose parts from carton.
#10 X 1-1/4”
Flat Head Screw
Pt# 52215
PAGE 1
EV-N-SPRED
EV-N-SPRED
EarthWay
EarthWay
®
®
2
600A-P
lus
E
stAtE
B
roAdcAst
s
PrEAdEr
ASSEMBLY and OPERATING INSTRUCTIONS
Rev. 3-10
HELPFUL HINTS:
REVIEW THE DIRECTIONS BEFORE ASSEMBLY
;
Make sure the
ARROW
on the gear box points to the front of the spreader. The impeller must turn clockwise. Reversing
the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use. Fertilizer stuck on the
impeller blades will cause uneven spreading.
;
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your
spreader thoroughly after each use. A coating of light spray oil will help prevent corrosion. Wash between the shut off
plate and bottom of the hopper.
;
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS REGARDING
THE SAFE OPERATION OF THIS SPREADER, PLEASE CONTACT US. THIS MODEL INCLUDES
LIFETIME TECHNICAL
SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
:
tEchsuPPort
@
EArthwAy
.
com
2.
Position hopper as shown to the right.
Install Frame using (4) #10 x 1¼” Flat
Head Phillips screws.
TIGHTEN
THESE NOW
3.
Install gear box by inserting the pinion shaft into hole in center of
hoppers bottom. The
ARROW
on the gearbox must point to
FRONT
of
the hopper. Follow label instructions on hopper.
FRO
NT
Arrow
