4.
Install Gearbox by inserting the pinion shaft into hole in
center of hoppers bottom. The word
“FRONT”
on the gearbox
must point to
F
RONT
of the hopper.
5.
Install axle bearings to both lower
handles. NOTE: Notch on bearings and
lower handles. Bearings must go
through flat side of lower handle.
3.
Install impeller onto pinion shaft. Insert 1/8” x 1-1/4” cotter pin
through impeller then through pinion shaft. Use hole nearest gear box.
Spread cotter pin to prevent from falling out. Next, install the Cross
Brace through the Gearbox Brace Support as shown above.
6.
Install Lower Handles onto Axle to both sides as shown above. Now insert 1-1/2” bolt through first hole in lower handle, then through
frame brace, and finally into the threaded connector in the Cross Brace.
[NOTE: Dimples on frame braces must be facing toward gearbox as
shown.]
DO NOT TIGHTEN YET.
Next insert 1-1/2” bolt through other end of frame brace and through second hole in frame install locknut.
DO NOT TIGHTEN YET.
Now insert 2-1/4” bolt through second hole in lower handle and through first hole in frame..
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
PAGE 2
