Page 28
OPERATOR INSTRUCTIONS ANd PARTS
MC43E & MC43 Mini Cultivator
GetEarthquake.com
800-45-6007
The Border-Edger Kit is a useful tool for making clean cuts in the lawn along the borders of gardens, flower beds,
walkways, and driveways for a well manicured look. To install the Border-Edger Kit, do the following:
1. Disconnect spark plug wire from spark plug.
2. Remove the cotter pins from both sides of the tine shaft.
3. Remove the cultivating tines from the shaft, remembering which direction they are facing.
4. Put the tines in a safe place and save the (2) cotter pins, they will be used on the Border-Edger Kit.
5. Slide the Border-Edger attachment on either side of the tine shaft. Make sure that the hub collar of the border
edger tine faces outward, away from the transmission of the mini cultivator.
6. Put (1) cotter pin, flat side facing edger attachment, through the shaft hole that is further down the shaft from the
hole where the cultivating tines were placed.
7. Slide the wheel on the opposite tine shaft.
8. Insert the remaining cotter pin, flat side facing wheel, through the hole next to the wheel at the end of the tine
shaft.
9. Re-connect spark plug wire.
10. Before using the Border-Edger Kit, remove the drag stake from the unit.
11. Set the mini cultivator wheels to their highest (top) position.
Ek4 Border-Edger Attachment kit
(fits both Models MC4 & MC4E)
CAUTION
BE AWARE ThAT ThE MINI CULTIVATOR COULd UNExPECTEdLY BOUNCE
UPWARd, OR jUMP FORWARd IF ThE TINES STRIkE CONCRETE, PAVEMENT,
OR OThER hARd SURFACES OR hARd OBSTACLES BURIEd UNdER GROUNd.
Ek4 BORdER-EdGER kIT INSTALLATION (OPTIONAL ACCESSORY)
Revised 1.15.08
Содержание MC43
Страница 2: ......
