EarthQuake MC43, Руководство оператора

Страница: 19 / 32

OPERATOR INSTRUCTIONS ANd PARTS
MC43E & MC43 Mini Cultivator
Page 1
GetEarthquake.com
800-45-6007
TROUBLEShOOTING
PROBLEM POSSIBLE CAUSE REMEdY/ACTION
Engine will not start 1. Power switch off 1. Flip switch to ON position
2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug
3. Out of fuel 3. Refuel
4. Spark plug wet, faulty or improperly
gapped 4. Clean, replace or gap spark plug
5. Throttle control not held open 5. hold throttle control open when pulling recoil
handle
6. Fuel line hose not positioned in bot-
tom of gas tank 6. Push fuel line down into fuel in gas tank
Engine runs rough, floods during
operation 1. Dirty air filter 1. Clean or replace air filter
2. Choke partially engaged 2. Turn off choke
3. Carburetor out of adjustment 3. Call factory
Engine is hard to start 1. Stale fuel 1. Drain old fuel and replace with fresh.
Use gas stabilizer at end of season
2. Spark plug wire loose 2. Make sure spark wire is securely attached to
spark plug
3. Dirty carburetor 3. Clean carburetor, use gas stabilizer, new gas can
4. Throttle control not held open 4. Prime unit 3 more times, then hold throttle open
when pulling recoil handle
Engine misses or lacks power 1. Clogged gas tank 1. Remove and clean gas tank
2. Clogged air filter 2. Clean or replace air filter
3. Carburetor out of adjustment or bad 3. Call factory
4. Spark plug wet, faulty or improperly
gapped 4. Clean, replace or gap spark plug
Engine runs, then quits 1. Gas cap not venting 1. Clean or replace gas cap, check vent
2. Plugged fuel filter 2. Clean or replace fuel filter
3. Carburetor out of adjustment or bad 3. Call factory
Engine revs too high 1. Carburetor out of adjustment 1. Call factory
Tines turn at idle 1. Idle speed too high 1. Adjust idle speed lower
2. Broken clutch spring 2. Replace spring
MOdEL MC4E ONLY
Charger won’t charge 1. Battery worn out 1. Replace with new batttery
2. Connectors not plugged in 2. Open battery box and connect battery connectors
Key won’t start machine 2. Battery not charged 1. Charge battery
contact service provider at 800-345-6007 if above remedies fail.