OPERATOR INSTRUCTIONS ANd PARTS
CRT Models 6015V, 6015VCE, 6015BCE
Page 7
GetEarthquake.com
800-345-6007
forward drive safety control lever
detent pin
forward cable
recoil start
wheel lock pin
belt guard
depth regulator lever
FEATURES
ATTACh hANdLEBAR (6015vCE, 6015BCE, EUROPE)
1. Locate handlebar extensions. (SEE FIGURE 1B)
2. Place handlebar extensions on outside of lower handlebar mount. Line
up the handlebar extension pieces with the lower handlebar mount as
shown in the decal located on the lower handlebar mount next to the
mounting location. (SEE PAGE 22)
3. Insert one 3/8-16 x 1 3/4" bolt for each side in lower holes. Put 3/8" flat
washers onto bolts.
4. Start 3/8-16 nuts on each bolt.
5. Insert one 3/8-16 x 1-3/4 bolt for each side in upper holes. Put 3/8" flat
washers onto bolts.
6. Start 3/8-16 nuts on each bolt.
7. Tighten 3/8-16 nuts on each of the 4 bolts connecting the handlebar
extensions to the lower handlebar.
8. Handlebar extensions should now be securely assembled to the lower
handlebar mount.
9. Now assemble the handlebar to the handlebar extensions. Note:
Handlebar goes to the outside of the handlebar extensions.
10. Insert one 3/8-16 x 1 bolt for each side in lower holes.
11. Start 3/8-16 nuts on each bolt.
12. Insert one 3/8-16 x 1 bolt for each side in upper holes.
13. Start 3/8-16 nuts on each bolt.
14. Tighten 3/8-16 nuts on each of the 4 bolts connecting the handlebar
to the handlebar extension.
FILL ENGINE CRANkCASE
1. Add oil according to engine manual. do not overfill. Use a clean, high
quality detergent oil. Use no special additives with recommended oils.
do not mix oil with gasoline. oil level must be full. Check the oil level
by removing oil fill plug. oil level should be up to the bottom of the fill
plug opening.
2. Always check oil level before starting engine. Refer to engine manual
for capacity and type of oil to use.
FIGURE 1B (For full drawing see page 26)
1
6
5
5
20
18
19
17
16
15
14
14
13
12
10
11
9
8
10
4
2
3
2
7