OPERATOR INSTRUCTIONS ANd PARTS
CRT Models 6015V, 6015VCE, 6015BCE
Page 6
GetEarthquake.com
800-345-6007
UNPACkING ANd ASSEMBLY
Your rototiller comes fully assembled except for a few parts. The following
instructions will help you unpack your tiller and assemble and adjust your
tiller’s depth regulator lever, cable tension and handlebar height. You will
need 2- 9/16” wrenches.
UNPACk 6015v (U.S. vERSION)
1. open top of carton and remove handlebar assembly.
2. Find parts packet. Parts packet contains:
4- 3/8-16 x 1 3/4” hex head bolts
4- 3/8-16 locknuts
1- 5/16-18 x 3/4” hex head bolt
1- detent pin
1- five star knob
4- 3/8” flat washers
3. Cut open end of carton and remove machine by:
a. Putting loose wheels onto machine with lock pin disengaged from
wheel.
b. Roll tiller from carton.
UNPACk 6015vCE ANd 6015BCE
(EUROPEAN vERSION)
1. open top of carton and remove handlebar assembly.
2. Find parts packet. Parts packet contains:
4 - 3/8-16 x 1 hex head bolts
4 - 3/8-16 x 1-3/4" hex head bolts
8 - 3/8-16 locknuts
1- 5/16-18 x 3/4" hex head bolt
1- detent pin
1- 5-star knob
4 - 3/8" flat washers
2- Handlebar extensions (part# 31329)
3. Cut open end of carton and remove machine by:
a. Putting loose wheels onto machine with lock pin disengaged from
wheel.
b. Roll tiller from carton.
ATTACh hANdLEBAR (6015v, U.S. vERSION)
1. Place handlebar stems on outside of lower handlebar mount and align
lower holes. (SEE FIGURE 1A)
2. Insert one 3/8-16 x 1 3/4” bolt for each side in lower holes at the desired
handlebar height. Put 3/8” flat washers onto bolts.
3. Start 3/8-16 nuts on each bolt.
4. Insert one 3/8-16 x 1 3/4” bolt for each side in upper holes. Put 3/8” flat
washers on to bolts.
5. Start 3/8-16 nuts on each bolt.
6. Tighten all 3/8-16 nuts.
CAUTION
!
dO NOT TRY TO LIFT ThE ROTOTILLER FROM ThE
CARTON.
dO NOT Add ENGINE OIL INTO GEAR CASE dIPSTICk
hOLE.
IMPORTANT
ThE RIGhT ANd LEFT SIdES OF YOUR
ROTOTILLER ARE dETERMINEd FROM
ThE OPERATING POSITION AS YOU FACE
ThE dIRECTION OF FORWARd TRAvEL.
ENGINE IS ShIPPEd FROM FACTORY
WIThOUT OIL. YOU MUST Add ENGINE
OIL BEFORE STARTING ENGINE.
TILLER TRANSMISSION IS ShIPPEd FROM
FACTORY WITh ThE PROPER AMOUNT OF
LIQUId GREASE.
FIGURE 1A
lower handlebar
mount
3/8" flat washers
handlebar stem
3/8-16 x 1 3/4" bolts
3/8-16 nuts
cover plate
transmission
gear case
dipstick
NO ENGINE OIL!
