Eaglemaster E1 Plus, Инструкция по эксплуатации

Страница: 13 / 21

Same instructions / operation as Channel-2 turbo time mode.
o operate it by press button at 2nd time , 2nd stage
unlock will be output for passenger side .
Turbo mode:
2nd stage unlock:
If programmed with the feature , t
-12-
-Channel-4 (-) output
(programmable)
:
This channel "Pink wire" is a negative (-500mA) output features, this feature can be
controlled
" Window output / Turbo mode / Horn".
Window close :
If programmed with the Window output feature, this channel will constant outputting for
35 seconds when system armed for window close feature.
Note: the sensor will be bypassed when window is output.
Turbo mode:
Horn pulse:
How to use your PIN code:
f the remote control has been lost or damaged, you can manually disarm your system by
enter your own PIN code .(
The system's factory-set PIN code is "6" )
Turning the Ignition switch from OFF to ON position, LED will start flashing, the times of
LED flashing is according to the PIN code numbers, while LED flash 6 times then turning
the ignition switch to the OFF position , the system will disarmed immediately and siren
will give 4-short chirps.
NOTE:
Each cycle of alarm triggering is only provide one time to set PIN code, otherwise the
owner must wait next cycle triggering and then set PIN code again to disarm the system.
If the owner forgot the PIN code number, must use "Emergency reset switch " to reset the
alarm system (please see "Emergency reset switch" ), after this emergency reset switch
has been activated, the system PIN code will resume back to the original factory PIN
code "6" .
Same instructions / operation as Channel-2 turbo time mode.
If programmed with Horn pulse output, for additional vehicle's horn honk output alert.
Anti Car-Jacking mode :
This feature will protect your vehicle in the event that there is an attempt to Hi-jack the
vehicle. Alternative
"Remote activation" or " ACC ON with door open and closed " is
available by programming . While system is trigger anti-car jack mode, lights will flash
once and the LED will fast flashing to show the system is enter anti-car jacking mode.
See under "anti-car jack mode table".
Remote activates:
To operate it when driving the car (ACC ON), press button for 3 sec. The parking
lights will flash once and the LED will fast flash to show the system is enter anti car-jack
mode.