Eaglemaster E1 Plus, Инструкция по эксплуатации

Страница: 12 / 21

- Channel-2 (-) output (programmable) :
This channel "Orange/black wire" is a negative (-500mA) output features, this feature
can be controlled
" Disarmed output / Turbo mode (engine running) / Dome light " ,
2nd killer:
If programmed with the feature , the channel will constant output when the system
disarmed, this feature normally for 2nd immobilizer. 40A relay is required, COM & NO.
Turbo mode(engine running):
Dome Light:
If programmed with the feature , the channel will constant output 30sec. when disarming .
-Channel-3 (-) output (programmable) :
This channel "Gray wire" is a negative (-500mA) output features, this feature can be
controlled
" Trunk open / Turbo mode / 2nd stage unlock" .
Trunk open :
if programmed with Trunk open feature, simply press and hold button over 2 seconds,
the channel will output for 1 second pulse , this feature normally for open the trunk.
Note: if trunk has been remote opened in arming position, trunk switch will delay sensing for
20 seconds, and the shock sensor will be bypassed.
If programmed with the Turbo mode, this feature for the car with turbo time keeps engine
running 3 minutes after arriving at your destination.
To operate this turbo mode by pressing for 2sec. while driving or ignition ON , the
siren will give one chirp and the LED will start flashing fast, at the time the system is in
standby turbo time mode, the owner must follow under process to activate the Turbo
mode:
(1) Within 15sec. Turn Acc off (engine still keep running), open and close door to leave
the car.
Note: If within this 15sec. press any button once will exit the mode, LED off.
(2) While leaving the car by open and close the door, within 5sec. press button once,
the system will arm immediately, however the engine will still keep running for 3-min
and then in armed. The 2-Way remote will respond under icons flashing as long as
turbo time finished.
Exit turbo mode :
Pressing button once within turbo time , the system will exit turbo mode and in armed.
NOTE:
1. In Turbo mode, the sensor zone trigger will be bypassed until the turbo time finished.
2. In Turbo mode, if door, hood or trunk has been triggered, engine will stop running and
alarming the system, and to disarm the system must use your PIN code.
-11-
2-way LCD display :
2-way LCD display :
Note:
(1) After leaving the car, within 5sec.
If press wrong button will exit mode.
(2) After leaving the car, within 5sec.
If without press button will exit
mode automatically.
In Armed position, if remote trunk open, the 2-way
LCD will display trunk icon and give one beep .
If trunk closed, trunk icon off and give one beep.