EAE EE-MR30, Инструкция по установке, эксплуатации и ремонту

Страница: 17 / 35

Installation, Operation and Parts Manual
EE-MR30
17
Start
Turn on the power switch
The lift is raised
Push the UP button
Turn on the power switch
The lift is lowered
Push the DOWN button
Start
5.3 Flow chart for operation
5.4 Operation instructions
The lift must be only used in a static position for lifting and lowering vehicles.
Only use this lift on a surface that is stable and capable of sustaining the load.
Do not use the lift on any asphalt surface.
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift ing platform.
Always lift the vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over t he
lift.
1. Make sure that you have read and understood the operation manual before operation.
2. Load vehicle on lift carefully. Position the lift adapters to contact at the vehicle manufacturer’s recommended lift points.
3. Push the UP button to raise until the rubber adapters contact the base of the vehicle.
4 . Check adapters for secure contact with vehicle. Raise the lift to expected working height.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Push the DOWN button to lower the lifting platform.
2. After the lifting platform is fully lowered, remove rubber pads and other tools to provide an unobstructed exit for moving vehicle from the
lift area.
3. Drive the vehicle away.