EAE EE-6215E, Инструкция по установке, эксплуатации, запасным частям и обслуживанию, Страница: 24 / 42

Installation, Operation and Parts Manual
EE-6215E
24
5.3 Operation instructions
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Always lift the
vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle adapters. Do not attempt to transport
a load on the lift.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over
the lift.
1. Park the vehicle between two posts.
2. Adjust the lifting arms until lifting trays are under the pick ‐ up positions of the vehicle and make sure the gravity of vehicle located
over the center of four lifting arms.
3. Turn on the Main power switch.
4. Push the”UP”button on the control box until lifting trays have touched the pick ‐ up positions of vehicle.
5. Keep on raising the vehicle making its wheels have a bit clearance off the ground and check again the stability.
6. Raise the vehicle to the excepted height, push the “Safety Lock” button to engage the mechanical safety lock. Check again the stability
and then perform maintenance or repair work underneath.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Push the “DOWN” button on the control box. Initially the carriage will go upwards about 5CM to release the safety lock. After that the
carriage starts descending. .
2. When the lift is fully lowered, position the lift arms and adapters to provide an unobstructed exit before removing vehicle from lift
area.
3. Drive the vehicle away.
Pos. Name Function
QS Power switch Control main power
HL Power indicator Show if electricity is connected
SB1 UP button Control the rising movement
SB2 Safety lock button Engage the mechanical safety lock
SB3 DOWN button Control the lowering movement
SB Emergency stop Cut off operation power in emergency case