EAE DA110, Руководство по эксплуатации продукта

Страница: 14 / 22

Product Manual DA110
EAE KNX DALI Gateway
DA110 R2.0
©
EAE Technology www.eaetechnology.com Page 13 / 21
No Function Name DPT Length Flags
15 0=Scene 1, 1=Scene 2 Scene 1.022 1 bit CW
This object is used for recalling scene 1 or scene 2.
(value “0” = recall scene 1, value “1” = recall scene 2
16…22 0=Scene 3…15, 1=Scene 4…16 same as before
23 Broadcast Switch Broadcast 1.001 1 bit CWU
This object is used to switch all connected DALI ballasts on or off. You can configure broadcast switched on
brightness value, using “Brightness value when switch on” parameter.
24 Broadcast Set brightness value Broadcast 5.001 1 byte CWU
This object is used to set the brightness value of all connected DALI ballasts.
25 Broadcast Relative dimming Broadcast 3.007 4 bit CW
This object is used to dim all connected DALI ballast. The brightness value is changed in the defined direction
with the parameterized speed.
C Increase or decrease the brightness 0 = Decrease
1 = Increase
Step-Code The amount of intervals into which the
range of 0 % … 100 % is subdivided or the
break indication.
- 001b…111b: Step
Number of interval =
(2)
( 𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠𝑠−1 )
- 000b : Break
GENERAL NOTE(Broadcast Control):
Broadcast control objects are not dependent to Individual control group objects. Thus, individually controlled
device statuses will not be taking into account for Broadcast control group objects.
If Broadcast Relative Dim group object is willing to used, Broadcast Switch or Broadcast Absolute Dim control
is required.
If Broadcast control applied firstly, status values will be taking into account for individual control group
objects.