Water Sensing Cable
LP-LPD Water Leak Locating Panel Quick Start Guide
Page 5 of 10
Operating Instructions for System Configuration
Setup of Device Address and Baud Rate
If LP-LPD is integrated into the monitoring system, LP-LPD panel must be assigned address. The factory
default address of all LP-LPDs is 0 and its baud rate is 9,600.Each LP-LPD must be an unique address and
same communication baud rate.
Please follow the steps below to set address of LP-LPD:
Power on LP-LPD, then turn the communication cable into RS232 signal vial RS485, and connect
it to the designated PC.
Launch the configuration software as shown in the following:
