EA Technology CableData CDC2, Руководство по эксплуатации

Страница: 26 / 59

EA Technology CableData Collector Operating Manual 1365/L/01/1
Page 22 of 54
When all of the settings have been entered, click the OK button to save the settings and
close the window. The main interface will now be loaded.
If the
Cancel button is clicked instead, the prompt shown in Figure 20 will appear. Clicking
Yes will close the settings screen and all changes will be lost. Clicking No will return you to
the settings screen where it is possible to click OK to save the changes.
Figure 20 - Prompt after clicking cancel on the settings screen without saving any changes
10.4 Operating the Software
First, connect the CableData Collector and power on the device. To run the software the
shortcut will be located in
Start > Programs > EA Technology > CableData Collector
10.4.1 Software Initialisation
When the main interface is run, the software will start by attempting to find the attached
CableData Collector device. During this process, the window shown in Figure 21 will be
present. The window will close once the instrument has been found.
Figure 21 - Searching for instrument at software start-up
This should take no more than 5 seconds. If there is a problem detecting the instrument, a
warning message will appear as shown in Figure 22. This error should only occur if the unit
is not connected correctly. In such case, please check that the USB cable is securely
connected, and click
Yes . On some laptops, not all of the USB ports will function correctly,
so it is advisable to attempt connecting the CableData Collector to a different USB port if this
error occurs. If the error message persists and the cable and laptop have been ruled out as
the source of the problem, then please contact EA Technology for further assistance.
The
CableData Collector must not be connected through a USB hub as this may cause
intermittent errors during data capture.