E2 Systems BE 481, Руководство пользователя

Страница: 5 / 28

5
General
This Drilling and Tapping Unit is designed for normal drilling, countersinking, reaming and tapping. In
applications requiring high-precision hole placement or when drilling into rounded or slanted surfaces, drill
bushings must be used.
To be able to use the unit, it must first be installed and fitted with control equipment. Regardless of how
simple the installation is performed, the unit must be fitted with necessary protective devices to avoid
personal injury. Special precaution must be taken to eliminate the risk of clothing, gloves, hair, etc. being
caught in the rotating tool.
The unit consists of many components and preassembled parts, the reliability of which is dependent upon
proper maintenance. The pneumatic and hydraulic systems include a number of seals. It is essential to keep
moving seal surfaces clean and free of marks and scratches.
Installation
This Drilling and Tapping Unit is only intended for use in machinery which applies to the Machine Directive
98/37/EG.
WARNING!
Never use the unit without being securely fastened and that appropriate security
arrangements have been organised.
Be careful with rotating and moving parts, to avoid personal injuries.
Ensure that the unit is disconnected from the main air-supply, before any maintenance.
1. We recommend that this unit is installed in a place with clean air and an ambient temperature of
+10 - +40º C (+50 - +104 F.).
2. The unit must always be mounted on a level surface (machined) and attached with six M8 screws. On
the bottom side of the unit = mounting surface, there is a 10 mm wide groove for align the unit.
See Fig. 1.
Fig. 1.
3. The protective guards covering the limit switches or linear transducer are not sealed. Make therefore
certain not spray coolant or simliar over them.