E-Tech S06-HAE, Руководство оператора с информацией по обслуживанию

Страница: 71 / 110

OPERATOR’S MANUAL with Maintenance Information
Storage
66
Observe and Obey:
√
The storage of the machine shall be as
follows, Incorrect storage may affect the
performance and service life of the machine
1 The machine should be stored indoor
coeditor and the ground should be firm and
level. If be stored in outdoor condition the
machine should be covered to prevent the
water and dust.
2 Ensure the machine have been cleaned
and the functional before stop to the
storage. Repair an maintain it if necessary.
3 Stop the machine in suitable position so as
the drive or move the machines
conveniently.
Rust protection
1 Before the machine is stored into the
storage. Inspecting the paint before the
machine is stored into the storage repaint
the machine partly all completely against
the damage.
2 For moving parts grease can be applied to
prevent rust, such as bearings, joints and
sliding rails
The machine be stored long
time cannot be used to service until it has been
inspected and maintained according to the
daily check procedure.
How to store the batteries
1 When storing the machine for a long time
(one month to six months) be sure to turn
off the main power switch, key switch and
emergency stop switch, fully charge. In
order to ensure that these batteries stay
ready for operation, the following charging
procedures must be applied:
The machine or check the voltage of each
battery on the machine once a month to
ensure that the voltage of battery is not
lower than 25.2V, otherwise please
charge the machine immediately.
2 When storing the machine for a long time
(half a year or more), should be fully
charged state. The batteries should be
removed from the machine. keep the
batteries being clean and ensure nothing
being placed on the top of batteries. The
batteries connection should be
disconnection as bellow. Disconnect the
wire from the negative pole first the
disconnect the wires from the positive pole.
The batteries should be connected as
bellow: First connect the positive power
wires with the positive pole then connect
the negative cable line to the negative pole
finally. In order to ensure that these
batteries stay ready for operation, the
batteries should be charged one time in
every quarter.
Lithium battery storage
1 When storing the machine for a long time,
be sure to turn off the main power switch,
key switch and emergency stop switch and
fully charge it
2 In order to avoid the loss of power and the
impact on the service life of the battery, the