27
• INSTALLING, REMOVING AND ADJUSTING
THE WHEEL GUARD
1. When installing the wheel guard, align the bulges
with the notches. (Fig. 1A)
2. Press down the protection cover makes it
counterclockwise to the degree suitable for working.
(Fig. 1B)
3. If required, increase the clamping force by tightening
the screw.
4. Tighten the clamping lock.
5. To remove the guard, release the clamping lock,and
reverse the procedure.
• INSTALLING AND REMOVING GRINDING
WHEEL
1. Fit the inner flange correctly onto the spindle shaft.
2. Place the grinding wheel on the flange. When fitting
the wheel with a raised center, make sure the raised
center is facing the flange.
3. Screw the outer flange onto the spindle shaft.
4. Press the spindle lock and rotate the spindle until it
locks in position.
5. Tighten the flange with a spanner.
6. To release the spindle lock, remove the wheel, loosen
the flange with a spanner.
• INSTALLING AUXILIARY HANDLE
1. When operating the tool must hold the auxiliary
handle
2. The auxiliary handle may be installed on either side
of the gear case. Position the auxiliary handle in the
location which offers best control and guard protec-
tion. To install, thread side handle into side handle
socket and tighten securely.
3. In the middle of the auxiliary handle has space to
keeping the spanner when it no needs to use. (Fig. 3)
GB
WARNING :
Always remove battery pack be-
fore changing or removing accessories. Only
use accessories specifically recommended
for this tool. Others may be hazardous.
WARNING :
To reduce the risk of injury, wear
safety goggles ore glasses with side shields.
ASSEMBLY INSTRUCTION
WARNING :
Before using, please install the
wheel guard.
WARNING :
Before installing or removing the
wheel guard, make sure that the power is off
and removing the battery.
Fig. 1A
Wheel Guard
Bulges
Clamping
lock
Notches
Screw
Fig. 1B
Spanner
Clamp Nut
Grinding Wheel
Inner Flange
Fig. 2
Inner Flange
Spindle Lock Button
Fig. 3
Auxiliary
Handle
Spanner
