e-Joe EPIK SWAN, Руководство пользователя

Страница: 10 / 21

5

Pedal Assist System (PAS) – Level selection
PAS comes with 5 levels of pedal assistance. There is no pedal assistance when
the level is set to 0. To change the PAS level, click UP or DOWN button to increase
or decrease the levels.
Every time you turn on LCD, it will automatically restore the most recent level. For
your safety and to avoid accidental use of the throttle, make sure to keep the PAS
on level 0 at all times when the bike is not in use.

Walk Power Assist
Riders can use up to 6 km/h power assist function when pushing bikes. Hold button
(DOWN) , the Walk Power Assist function logo flashes and the bike moves at the
speed of no more than 6 km/h. Release button (DOWN) , the assist function will be
revoked.

Backlight and Headlight
Hold button (UP) for a couple of seconds to turn on the backlights as well as the
headlights. The lights indicator turns on when the lights are on. Hold button (UP)
long again to turn off backlights and headlights.

Battery Capacity Indicator
When the battery is fully charged, the icon shows four full bars on the top left corner of the display. When the battery is
low on change, the indicator starts flashing.
Voltage shortage flashes

Single Data Clearing
5 seconds after the LCD is powered on, at interface 1, hold both the button (UP)
and the button (DOWN) simultaneously for about 2 seconds, the single trip time
(TM) and single trip distance (DST) flash, then hold button shortly (SW), the record
contents of both will be cleared.
When the data is flashing, if there is no operation on the data within 5 seconds, the
LCD will automatically return to interface 1, and the original content will be saved.

Error Code Definition
When the electric control system of the bike is out of order, the display automatically
displays the error code and stops working correctly. The reason for the error is
shown in the error code definition table below.
Error Code Definition
01_info Throttle abnormality
03_info Motor hall signal abnormality
04_info PAS Sensor signal abnormality
05_info Axis speed sensor abnormality (only applies to torque system)
06_info Motor or controller abnormality