E.H. Wachs 06-150-510-MAN, Руководство пользователя

Страница: 21 / 60

Chapter 5 , Operating Instructions
E.H. Wachs Company Part No. 06-150-510-MAN, Rev. 0-0607 17
Chapter 5
Operating
Instructions
The Guillotine pipe saw can be installed on a pipe in any
orientation—horizontal, vertical, or at an angle. Once the
saw is clamped into place, you will release tension on the
lift to allow the clamping mechanism to support the saw.
Refer to Chapter 3 if necessary for identification of the
machine’s components. The Super D is operated from the
topside control unit (TCU); fig shows the instruction panel
on the top of the TCU.
Figure 5-1. The instruction label on top of the TCU
provides brief instructions for operating the saw.
M
ACHINE
S
ET
-U
P
Before lifting the Guillotine Super D, make sure the feed
drive is at its starting point. (The saw bow should be
retracted all the way back from the V saddle.) Ensure that
the blade is sharp; install a new blade if necessary (see
Chapter 6 for instructions).
In This Chapter
M
ACHINE
S
ET
-U
P
O
PERATION
R
EMOVING THE
S
AW