22
2. Slide a .046" x 11
1
/
4
" carbon rod from
the lower fuselage to the upper side force
generator. Leave at least 1/16" of the rod
exposed at both ends. Glue only the rod at the
fuselage. Apply foam-safe CA to the rod both
at the inside and outside in order to capture the
rod in position.
3. Place the top wing on a surface that will allow
the wing panel to lie perfectly flat. Apply glue to
the inside edge of the rod. Once the glue fully
cures carefully lift the airframe and apply CA to
the top of the rod.
4. Repeat Steps 2 and 3 for the opposite side.
