19
E-flite Sukhoi SU-26m 480 ARF Assembly Manual
2. Use a pin drill and 1/16-inch (1.5mm) drill bit
to drill holes through the servo mounting tabs and
into the fuselage.
3. Apply 2–3 drops of thin CA into each of the two
holes to harden the surrounding wood.
4. Use a #0 Phillips screwdriver and the screws
provided with the servo to secure the elevator servo
in the fuselage.
5. Use side cutters to remove one of the arms from
a 3D servo horn. Use a pin drill and 1/16-inch
(1.5mm) drill bit to enlarge the outer hole of the
servo horn.
6. Attach the micro control connector to the servo
horn. Be sure to use the included retainer to secure
the micro control connector.
7. Center the elevator servo. Use a #0 Phillips
screwdriver to remove the stock servo horn and
install the horn prepared in the previous steps.