EN
19
WARNING:
Do not perform this or any other equipment maintenance with
the propeller installed on the aircraft. Serious injury or property damage
could result from the motor starting inadvertently.
NOTICE:
Crash damage is not covered under warranty.
NOTICE:
After any impact or replacement always ensure the fl ight control-
ler/GPS module is secure in the fuselage. If you replace the fl ight controller,
install the new fl ight controller in the same location and orientation as the
original or damage may result.
Thanks to the EPO foam material the aircraft,is made of, repairs can be made using
virtually any adhesive (hot glue, regular CA [cyanoacrylate adhesive], epoxy, etc).
When parts are not repairable, see the
Replacement Parts
list for ordering by
item number.
Service and Repairs
Service of Power Components
WARNING:
Always disconnect the fl ight battery
from the model before removing the propeller.
Disassembly
1. Remove the screw
(A)
and spinner
(B)
.
2. Remove the 4 screws
(C)
holding the motor mount
(D)
to
the fuselage.
3. Disconnect the motor wires from the ESC wires.
4. Remove the 4 screws
(E)
holding the motor
(F)
to the
motor mount.
Assemble in reverse order.
Assembly Tips
• Correctly align and connect the motor wire colors with
the ESC wires.
Users who wish to upgrade to the BNF with FPV system can add the necessary
replacement parts and achieve the same functions. Compass calibration is
required after installing a new GPS/compass.
Required parts:
•
SPMA3235 Flight Controller
•
SPMA3173 GPS Module
•
SPMVC602 FPV Camera
• SPMVT1001/SPMVT1001EU
VTX
Flight Controller Plug Connections
Bind - Bind
1– Throttle
2– Right Elevon
3– Left Elevon
4– N/A
5– N/A
6– Video Transmitter
7– Voltage
8– Current
GPS
8
7
6
5
4
3
2
1
Bind
SPMA3235 Flight Controller Connections
Upgrading PNP and BNF Basic
GPS
