E-FLITE Leader 480 ARF, Инструкция по сборке

Страница: 4 / 32

4 E-flite Leader 480 ARF Assembly Manual
hardware/Accessory Sizes
Wheel diameter 2-in (51mm)
Wing bolts 3mm x 10mm socket
head cap screw
Recommended Radio Equipment
You will need a minimum 4-channel transmitter,
receiver and four servos. You can choose to purchase
a complete radio system. If you are using an
existing transmitter, just purchase the other required
equipment separately. We recommend the crystal-
free, interference-free Spektrum ™ DX6 2.4GHz DSM ®
6-channel system. If using your own transmitter, we
recommend the following radio equipment.
If you own the Spektrum DX6i radio, or you are
using a different DSM2
™
radio, just add the AR6115
6-channel DSMX microlite receiver and four E-flite
®
DS76 servos.
Complete Radio System
SPM6610 DX6i DSMX 6CH system
Or purchase Separately
SPMAR6115 AR6115 6CH DSMX ™
Microlite Receiver
EFLRDS76 DS76 Digital Servo (4)
EFLREX3L 3-inch (76mm) Servo Extension
EFLREX6L 6-inch (152mm)
Servo Extension (3)
480 Motor Setup
EFLM1515 Park 480
EFLA1040L 40-Amp Pro Lite SB
Brushless ESC
EFLB21003S30 2100mAh 3S 11.1V 30C Li-Po,
12AWG EC3
APC12060E 12 x 6E Electric Propeller
Optional Accessories
EFLA110 Power Meter
EFLC505 Intelligent 1- to 5-Cell
Balancing Charger
EFLAEC312 Charge Lead with 12-inch
Wire and Jacks, 16AWG
EFLSP175 1
3
/
4
-inch Aluminum Spinner
with 4mm and 5mm Collets
EFLA156 1/9 Civilian Pilot, Blue
with Glasses
Required Tools and Adhesives
Tools & Equipment
Box wrench: 10mm Felt-tipped pen
Flat file Hex wrench: 1.5mm, 2.5mm
Low-tack tape Pin vise
Ruler Scissors
Side cutter Square
T-pins Two-sided tape
String or dental floss
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
Hobby knife with #11 blade
Phillips screwdriver: #0, #1, #2
Optional Tools & Equipment
Balancing stand (optional)
Adhesives
Medium CA PAAPT02
Thin CA PAAPT08
Threadlock PAAPT42
Before Starting Assembly
Before beginning the assembly of your model, remove
each part from its bag for inspection. Closely inspect
the fuselage, wing panels, rudder and stabilizer for
damage. If you find any damaged or missing parts,
contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun
(HAN100) and covering glove (HAN150) or covering
iron (HAN101) with a sealing iron sock (HAN141) to
remove them. Use caution while working around areas
where the colors overlap to prevent separating the
colors.
During the course of building your model we
suggest you use a soft base for the building surface.
Such things as a foam stand, large piece of
bedding foam or a thick bath towel will work well
and help protect the model from damage during
assembly. This is not shown in the instructions
to provide the greatest detail in the photos.