15
E-flite Hawker Sea Fury 480 ARF Assembly Manual
2. Use sandpaper to remove any irregularities from
the fin and rudder.
3. Mount the control horn to the rudder as shown
using two 2mm x 10mm sheet metal screws, control
horn backplate and a #1 Phillips screwdriver.
4. Cut slots in the rudder for the three rudder
hinges. Use thin CA to glue the hinges half-way
into the rudder as shown.
5. Use a pin drill and 1/8-inch (3mm) drill bit to
drill a hole for the tail gear wire in the rudder.
6. Hold the rudder against the fin and use a felt-
tipped pen to transfer the location of the hinges
to the fin.
7. Use a hobby knife to cut the slots for the rudder
hinges in the fin.
