E-FLITE Habu 32 EDF ARF, Инструкция по сборке, Страница: 29 / 56

29 E-flite Habu 32 EDF ARF Assembly Manual

13. Use a flat file to make a 1/4-inch (6mm) wide
flat area on the gear near the end of the axle strut
for the setscrew to rest. This will keep the wheel
collar from vibrating loose in flight.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.

14. Slide a 3.5mm aluminum wheel spacer on
the axle, then the wheel with adapters. A 3.5mm
wheel collar is used to secure the wheel in position
by tightening the setscrews onto the axle using a
1.5mm hex wrench.
The end of the axles may have a slight bur
on them from the factory. If the wheel is hard
to install use a file to remove this bur.
Nose Gear Installation - Retracts
Required parts
Fuselage assembly Nose gear retract assembly
Transmitter
Receiver
Receiver battery Silicone tubing
Metal clevis (2) 2mm nut (2)
Threaded rod, 2
1
/
4
-inch (57mm)
Servo with hardware (MC35)
3mm x 8mm socket head screw (4)
Aluminum wheel collar with setscrew, 3.5mm
Aluminum wheel spacer, 3.5mm
Wheel, 1
3
/
4
-inch (44.5mm)
Wheel axle adapter set
Required Tools and Adhesives
Pliers Phillips screwdriver: #1
Side cutter Hobby knife with #11 blade
Rotary tool Sanding drum
Threadlock Clear tape
Hex wrench: 1.5mm, 2.5mm

1. Use a #1 Phillips screwdriver to remove the four
2mm x 8mm self-tapping screws that secure the
nose gear cover to the fuselage. Set the cover and
screws aside until later in the section of the manual.