E-FLITE Habu 32 EDF ARF, Инструкция по сборке, Страница: 18 / 56

18 E-flite Habu 32 EDF ARF Assembly Manual
Main Landing Gear Installation -
Fixed Gear
Required parts
Wing panel assembly (right and left)
Aluminum wheel collar with setscrew, 3.5mm (2)
Aluminum wheel spacer, 3.5mm (2)
Wheel, 1
3
/
4
-inch (44.5mm) (2)
Wheel axle adapter set (2)
Main landing gear strut (right and left)
Main fixed landing gear unit (2)
3mm x 14mm countersunk self-tapping screw (8)
Required Tools and Adhesives
Drill Drill bit: 5/64-inch (2mm)
Threadlock Hex wrench: 1.5mm
Thin CA Phillips screwdriver: #1
Trim seal tool Hobby knife with #11 blade
Triangle Flat file
Note : If you are installing retracts, skip to the
next section of this manual, Main Landing Gear
Installation - Retractable Gear.

1. Use a hobby knife with a new #11 blade to
remove the covering to access the landing gear
mounts. Leave 1/32-inch (1mm) of covering
around the inside edges. Use a trim seal tool to
iron down the covering around the edges to finish
the opening.

2. Place a main landing gear block in the wing.
It may distort the covering slightly during its
installation. Make sure it is resting flat on the
landing gear rails.

3. Prepare a 5/64-inch (2mm) drill bit by wrapping
a piece of low-tack tape around the drill bit 5/8-
inch (16mm) from the end of the bit. This will act as
a marker so you don’t accidentally drill through the
top of the wing. Place the drill bit in a drill.

4. Use the drill and drill bit prepared in the
previous step to drill the four holes for the landing
gear block mounting screws.

5. Remove the landing gear block from the wing.
Use a #1 Phillips screwdriver to thread a 3mm x
14mm countersunk self-tapping screw in each hole
to cut threads into the landing gear rails. Remove
the screws after threading the holes.