❍
3. Separate the tail assembly from the fuselage.
Remove the covering from inside the lines
using a sharp hobby knife.
❍
4. Place the tail assembly back in position. Before
using medium CA to attach the tail assembly to
the fuselage, stand about 10 feet away and
see if the stabilizer and wing are parallel.
Apply the CA to the slot in the fuselage where
the fin fits, and to the top of the fuselage
where the stabilizer rests. Allow the CA to fully
cure before continuing.
❍
5. Use hinge tape on both sides of the fuselage
and rudder to hinge the bottom section of the
rudder to the fuselage
13
