11
E-flite F-86 Sabre 15 DF ARF Assembly Manual
7. Repeat Steps 1 through 6 to prepare the
opposite side of the fuselage for the wing.
8. Apply a thin layer of 15-minute epoxy to the
fuselage where it was sanded previously.
9. Apply a thin layer of 15-minute epoxy to the
short and long wing rods before you insert them
into the wing.
10. Apply a thin coat of 15-minute epoxy on the
end of the wing that will butt against the fuselage.
11. Slide the wing into position against the
fuselage. Use low-tack tape to keep the wing tight
against the fuselage until the epoxy fully cures.
12. Repeat Steps 8 through 11 to install the
remaining wing panel to the fuselage.
13. Before the epoxy cures, use a paper towel
and rubbing alcohol to remove any excess epoxy
that may have oozed out from the joint between
the wing and fuselage.
