28
E-flite Eratix 3D 25e ARF Assembly Manual
The control throw measurements are taken at the widest
point on the surface.
Low Rate
High Rate
Ailerons:
Up
1-inch (25mm)
3-inch (76mm)
Down
1-inch (25mm)
3-inch (76mm)
Elevator:
Up
1-inch (25mm)
3
1
/
2
-inch (90mm)
Down
1-inch (25mm)
3
1
/
2
-inch (90mm)
Rudder:
Right
2-inch (51mm)
4
1
/
2
-inch (114mm)
Left
2-inch (51mm)
4
1
/
2
-inch (114mm)
These are general guidelines measured from our own
flight tests. You can experiment with higher rates to match
your preferred style of flying.
Center of Gravity
An important part of preparing the aircraft for flight is properly
balancing the model.
Caution
: Do not inadvertently skip this step!
The recommended Center of Gravity (CG) location for the
Eratix 3D 25e is 3
1
/
4
inches (83mm) to 4 inches (102mm) back
measured from the center of the leading edge of the wing next
to the fuselage.
After your first flights, the Center of Gravity can be adjusted for
personal preference.
