20
E-flite Eratix 3D 25e ARF Assembly Manual
2. Remove the hatch from the fuselage. Slide the wing
panel with tube into position on the fuselage.
3. Slide the remaining wing panel into position. Secure
the panels using 4-40 x
1
/
2
-inch machine screws with #4
washers (silver) using a 3/32-inch hex wrench.
4. Repeat Steps 2 and 3 for the remaining wing panel.
Stabilizer and Elevator
Required Parts
• Fuselage w/wing installed
• Stabilizer
• Elevator
• CA hinge (4)
• Elevator joiner wire
Required Tools and Adhesives
• Hobby knife
• Felt-tipped pen
• Ruler
• T-pins
• Thin CA
• Sandpaper
• 30-minute epoxy
1. Position the stabilizer into the slot in the aft end
of the fuselage. Check that the stabilizer is centered
in the fuselage.
