EN
Battery Installation and ESC Arming
Battery Selection
We recommend E-fl ite
®
2200-3200mAh 11.1V 3S- 4S 30C Li-Po batteries. If
using a battery other than those listed, the battery should be within the range
of capacity, dimensions and weight of the E-fl ite Li-Po battery packs to fi t in the
fuselage. Be sure the model balances at the recommended CG.
1. Lower the throttle and leave the trim in the neutral position. Power on the
transmitter, then wait 5 seconds.
2. Push the canopy latch button (
A
) to release the canopy and remove.
3. For added security apply the loop side (soft side) of the optional hook and
loop tape (
B
) to the bottom of your battery and the hook side to the battery
compartment.
4. Install a fully charged 2200mAh battery (
C
) all the way forward in the
battery compartment as shown.
IMPORTANT
Adjust the battery position for proper CG accordingly.
5. Connect the battery to the ESC. (the ESC is now armed).
6. Keep the aircraft immobile, upright and level, and away from wind or the
system will not initialize.
• The ESC will sound a series of tones (refer to step 6 of the binding
instructions for more information).
• An LED will light on the receiver.
• The elevons with cycle up and down two times to indicate that the
aircraft has initialized.
If the ESC sounds a continuous double beep after the fl ight battery is
connected, recharge or replace the battery.
7. Reinstall the canopy by inserting the front tab fi rst and pushing down on the
back of the canopy until the latch locks.
7
C
CAUTION:
Always
keep hands away
from the propeller. When
armed, the motor will turn
the propeller in response to
any throttle movement.
