EN
Conscendo Evolution1.5m
4
Preflight
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the flight battery.
4 Setup Transmitter using transmitter setup chart
5 Fully assemble the aircraft.
6 Install the flight battery in the aircraft (once it has been fully charged).
7 Check the Center of Gravity (CG).
8 Bind the aircraft to your transmitter.
9 Make sure all linkages move freely.
10 Perform the control direction test with the transmitter.
11 Perform the AS3X reaction test with the aircraft
12 Adjust the flight controls and transmitter as needed.
13 Perform a radio system range test.
14 Find a safe open area to fly.
15 Plan flight for flying field conditions.
Transmitter Setup (BNF)
IMPORTANT:
After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
If your transmitter allows it, enable the throttle cut feature. Always engage throttle
cut before approaching the aircraft.
Dual Rates
Low rate is recommended for the initial flights.
NOTICE:
To ensure AS3X
®
technology functions properly, do not lower rate
values below 50%. If lower rates are desired, manually adjust the position of the
pushrods on the servo arm.
NOTICE:
If oscillation occurs at high speed, refer to the Troubleshooting Guide
for more information.
Expo
After first flights, you may adjust expo in your transmitter.
Computerized Transmitter Setup
(DX6i, DX6e
‡
, DX6
‡
, DX7, DX7S, DX8, DX9, DX10t, DX18, DX20 and iX12)
Start all transmitter programming with a blank ACRO model (do a model reset),
then name the model.
Set Dual Rates to:
HIGH 100%
LOW 70%
Set Servo Travel to:
100%
DX6i
1. Go to the SETUP LIST MENU
2. Set MODEL TYPE: ACRO
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: Normal
DX6e
DX6
DX8e
DX8
DX9
iX12
†
iX20
†
1. Go to the SYSTEM SETUP (Model Utilities)
†
2. Set MODEL TYPE: AIRPLANE
3. Set AIRCRAFT TYPE (Model Setup, Aircraft Type)
†
:
WING: Normal
†
Some of the terminology and function locations used in the iX12 programming
may be slightly different than other Spektrum AirWare™ radios. The names given
in paranthesis correspond to the iX12 programming terminology. Consult your
transmitter manual for specific information about programming your transmitter.
Installing the Tail
1. Slide the horizontal stabilizer tube into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal stabilizer as shown. Ensure the
control horn faces down.
3. Secure the 2 piece tail in place with the 2 included pieces of tape. Install a
piece of tape on the top and bottom of each horizontal tail section as shown.
Model Assembly
