21
E-flite AT-6 Texan ARF Assembly Manual
5. Position the servo between the servo mounting block.
Use a pencil to mark the locations for the servo mounting
screws on the blocks. The servo should not touch the
cover to prevent it from absorbing vibrations from the
airframe. You may have to notch the servo block to allow
access for the servo wire.
6. Use a drill and 1/16-inch (1.5mm) drill bit to drill the
holes for the servo mounting screws.
7. Apply a few drops of thin CA to each of the
holes drilled in the previous step to harden the
surrounding wood.
8. Use a #1 Phillips screwdriver to install the screws
provided with the servos to attach the servo to the
servo mounting blocks.