INSTALLATION
2-3
February 2001
Part No. 001-9800-001
Figure 2-2 Remote Mount Installation Components
Item
No.
Description
Part No.
Item
No.
Description
Part No.
1
Low profile mounting bracket
017-2229-010
9
Hanger ground wire assembly
023-7171-911
2
Screw, No. 10 self-drilling (4)
575-9077-545
10
Amplified dynamic microphone
250-0740-300
3
Tri-knob (2)
547-0016-008
11
Remote control unit
---
4
Accessory pigtail cable (optional) 597-9800-003
12
Tri-knob (2)
547-0016-008
5
Accessory wire kit (optional)
023-9750-011
13
Mounting bracket, control unit
017-2227-057
6
10-ft. DC power cable & hardware 023-9800-410
14
Screw, No. 10 self-drilling (4)
575-9077-545
22-ft DC power cable & hardware 023-9800-422
15
Flat washer, vulcanized (2)
596-6400-030
7
Microphone hanger
023-3514-001
16
Extension control cable, 11 ft (opt.) 597-9800-009
8
Screw, 4-24 x 5/16” sheet metal (3) 575-3604-010
17
5”, 4.7 ohm external spkr (optional) 250-0151-010
NEG
POS
+
1
2
3
Miniature
UHF Jack
Antenna
4
5
6
7
8
9
10
11
12
13
14
15
17
16
1 ft.
5 ft.
6 ft.
11 ft.
10 or 22 ft.
2.3 POWER CABLE INSTALLATION
It is recommended that both wires of the power
cable be connected directly to the vehicle battery.
Connection of either wire to other points may result in
increased interference from the vehicle’s electrical
system. If noise is still a problem with both wires
connected to the battery, a noise filter should be used.
NOTE: With LTR-Net models, do not connect the
power cable to a switched power source such as the
ignition switch or a relay. Always use the front pane
l
p
ower switch or the ignition sense input described in
Section 2.4.3 to switch power. When power is switched
externally with LTR-Net models, the de-registration
message cannot be sent and the current user settings
are not saved.