Document:
Date
Created By:
ECO#
LPN00670X0003A0_A
10-30-2019
TMT
011204
INSTALLATION INSTRUCTIONS
E-FFC14, E-FFC19, E-FFC24, and
E-FFC36 Series
www.e-conolight.com | 888.243.9445 | FAX: 262.504.5409
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before
installation.
DANGER
– Risque de choc – Couper l’alimentation
avant l’installation.
2. This Product Must Be Installed In Accordance With The
Applicable Installation Code By A Person Familiar With
The Construction And Operation Of The Product And
The Hazards Involved.
Ce Produit Doit Être Installé Selon Le Code D’installation
Pertinent, Par Une Personne Qui Connaît Bien Le
Produit Et Son Fonctionnement Ainsi Que Les Risques
Inhérents.
3. Suitable for Wet Locations.
Adspte pour les Endroits Mouiles.
4. Suitable for mounting within 1.2 m (4 ft) of the ground.
Peut être installé à moins de 1,2 m (4 pi) du sol.
5. Keep combustible and other materials that can burn away
from lamp/lens minimum 3 inches.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
1.
Connect cord leads inside wiring housing to fixture leads using
supplied wire nuts. Connect cord green wire to fixture ground wire
(green). Connect cord white wire to fixture common wire (white).
Connect cord black wire to fixture voltage wire (black). See
Figure 1.
2.
Attach wiring housing to inner (4) threaded holes on fixture
housing using supplied Allen bolts and Allen wrench. Tighten bolts
to 132 in-lbs (14.9 N•m).
3. Remove black plugs from (4) outer threaded holes. Attach upper
yoke bracket to (4) outer threaded holes using supplied Allen bolts
and Allen wrench. Tighten bolts to 132 in-lbs (14.9 N•m).
4.
Mount fixture in intended location using (2) customer supplied
³⁄
8
" (10 mm) fasteners and washers appropriate for the mounting
surface.
NOTE:
Slots in lower U-bracket can be used as a template for
locating holes on mounting surface.
5.
Aim fixture by loosening (2) center bolts and removing (2) outer
bolts on sides of lower U-bracket. Rotate fixture to desired tilt
angle. Once fixture is properly aimed, line up outer holes in upper
and lower U-brackets. Reinsert bolts into outer holes of U-bracket
to lock tilt angle. Tighten (4) bolts on sides of U-bracket to 132
in-lbs (14.9 N•m).
6.
Make wiring connections to cord leads exiting wiring housing per
the
Electrical Connections
section.
U-BRACKET MOUNTING
(Requires use of E-ACU-FFC-LRG Accessory)
FIGURE 1
Inner Threaded
Holes
Outer
Threaded
Holes
Gasket
(8) Allen Bolts
Wiring
Housing
Upper
U-Bracket
Lower
U-Bracket
Outer
Threaded
Holes
(1) Outer Bolt on Each
side of U-Bracket
(1) Center Bolt on Each
side of U-Bracket
