Manual for Power Pack compatible for Bosch* Classic (+) drive system
* Bosch is a trademark of the Robert Bosch GmbH
Page
7
of
9
-
Do not take remove the HMI during charging process!
Once you remove the HMI of your eBike during charging, the capacity indication
LEDs turn off. The charging process is continued indeed, but even if you install the
HMI again, you will not see the capacity indication LEDs again.
During charging, the capacity is indicated by lighting and flashing of the battery’s
LEDs as follows:
LED 1 flashing:
0
– 20 % charged capacity
LED 1 lighting and LED 2 flashing:
21
– 40 % charged capacity
LED 1,2 lighting and LED 3 flashing:
41
– 60 % charged capacity
LED 1,2,3 lighting and LED 4 flashing:
61
– 80 % charged capacity
LED 1,2,3,4 lighting and LED 5 flashing:
81
– 99 % charged capacity
LED 1,2,3,4 and 5 lighting:
100 % charged capacity
Break up of charging process
- To complete the charging, switch off the charger and unplug the charging plug of the
battery. Reattach the cap of the charging socket and pull the power plug of the charger from
the wall socket.
- If you charged your battery within your eBike, so please turn off and on your drive system,
so that it can calculate the range.
Charging with your original charger is completed, as soon as all LEDs are lighting
permanently.
With the E-Bike Vision fast charger, charging is completed, as soon as all LEDs of the
battery are lighting and charger LED is lighting solid green or red.
If the charger’s LED lights red, this is no cause for concerns. This can signalise for
example, that the battery management system has finished charging for balancing the
individual cell voltages of the installed cells. This ensures the lifetime and the safety
of your battery.
Charging time
The battery with a capacity of 13 Ah requires about 4 hours to be fully charged with the
standard charger and about 2 hours with our fast charger.
The battery with a capacity of 17 Ah requires about 5 hours to be fully charged with the
standard charger and about 3 hours with our fast charger.
Of course, you can continue to use your old charger. Please proceed as described
within the manufacturer’s manual.
ATTENTION: Charge your Power Pack always with minimum 4A charge current (that is
called the so called rapid charging)!
If you own the first generation charger (metallic housing), please make sure that you charge
in the rapid charge mode (indicated by the flashing charger LED).