Manual for Power Pack compatible for Bosch* Classic (+) drive system
* Bosch is a trademark of the Robert Bosch GmbH
Page
6
of
9
The Charging
The charging outside the pedelec is started by unlocking the lock, that way you can remove
the battery as usual and charge it in your appartement or garage in your presence.
Turn off the drive system and wait until the LEDs of the battery expire. Only now, you unlock
the lock with the key counter-clockwise to the left.
When using the E-Bike Vision charger you are able to charge your battery in or outside the
battery.
The drive system must be turned off.
Simply open the cap.
Under the cap, the 4pin connector for the E-Bike Vision charger is located.
Start of charging process with E-Bike Vision charger
-
Connect the charger to the mains.
-
Turn on the charger and wait until the green LED flashes slowly.
-
Make sure that none of the battery LEDs
are lighting when it’s not mounted in the
eBike.
-
Now plug in the charging connector of the charger to the battery.
-
In the charging socket of the battery and in the charging plug of the charger, there are
guide slots to prevent the charging plug to be inserted incorrectly. Please turn the
charging plug slightly, when you plug it in the socket of the battery, until it is in it’s right
position. This manifests itself by a slight snap. Now, the charging plug can be inserted
with light pressure. Please do not try to push the charging plug into the charging socket
with too much force, otherwise you could damage the battery or the charger.
-
Charging process starts and the fan turns on. The LEDs of the battery corresponding to
it’s current state of charge begins to flash.
-
If the battery is almost fully charged (4 LEDs are lighting and the 5th is flashing),
the fan will not start turning under certain circumstances, because the charger
switches immediately into the so-called constant voltage mode. Within this mode,
the power consumption of the charger is that low that the running of the fan is not
necessary.
Furthermore, the fan will also turn off towards the end of charging process, as it is
no longer needed in constant voltage mode.