Dytran Instruments, Inc. 21592 Marilla St. Chatsworth, CA 91311 Phone: (818) 700-7818 Website:
email: [email protected]
Page | 6
acquisition records events defined by acceleration level. Prior to triggering the device
records 256 samples per axis of pre-triggered samples and 10,240 samples per axis of post triggered
samples. Each event is saved in separate files with the time stamp of the triggered event.
is used to setup the trigger level
trigger channel allows the selection of the channel to apply the triggering level to (or if “Any”
is selected the device will trigger if any of the channels cross the threshold)
Figure 4: Trigger channel selection
selection allows the recording to start on a user selected time (any time up to 24 hours
into the future). User shall use the menu shown below to setup time (hours, minutes, and seconds) for
the recording to start
Figure 5: Trigger time selection
Six different sampling rates are available. See section on anti-aliasing filters to determine
the usable bandwidth of the measurements
Figure 6: Sampling rate selection
Eight different sensitivity units are available for use with IEPE accelerometers, velocity
sensors, force sensor and pressure sensors in Metric and Imperial units.
