dyras PB-460, Руководство пользователя, Страница: 9 / 61

Using the blender
1. Place the appliance on a flat, stable work surface. Ensure the base unit will remain
ventilated during use; remove any material (e.g. a soft tablecloth, paper etc) that could
cause problems.
2. Remove the mixing jug from the base unit. Remove the lid and fill the jug with your chosen
ingredients. Avoid filling the jug to the 'max' marking if you are using thin liquids. To
prepare larger quantities, simply make a number of smaller batches. (Remember to allow
the machine to rest after a maximum 60 seconds use).
Always place liquids in the measuring jug before adding any solid ingredients. Solid foods
(e.g. vegetables, fruit or meat) should be cut into small pieces before placing them in the
jug. Do not fill the mixing jug beyond the halfway mark (0.75l) when using coarsely-
chopped food. After adding your ingredients, fit the lid on the jug and insert the feed
opening cap. (Make sure the lid fits tightly). Wipe any moisture or food from the outside of
the jug.
When preparing the ingredients to be blended, the 30 x 60 millilitre blending funnel can be
used to measure the ingredients.
3. Place the mixing jug on the base unit as described previously. Make sure the speed control
switch is turned off (shown as '0') and then plug the blender into a mains socket.
4. You can operate the appliance either by using the speed control switch (part no.6) or the
'pulse' switch (part no.7).
While the device is in operation, with one hand always make sure the blender jar is
fastened to the motor unit. This way consequences arising from any possible shaking can
be avoided.
Pushing the ‘Pulse’ button halfway down corresponds to fixed speed setting 1 (low speed
gear), while pushing the button all the way down initiates speed setting 2 (high speed
gear).
Only activate the ‘Pulse’ and ‘Auto Clean’ buttons in speed setting ‘0’!
PB-460
EN
9
User'sManual for PB-460_User's Manual for PB-460 2016.08.02. 19:02 Page 9