dyras PB-460, Руководство пользователя, Страница: 11 / 61

time. Chop ice by using the 'pulse' switch (part no.7) in short bursts. Stop when the ice
becomes a pulp.
3. Cut larger ingredients into smaller (2-3cm) pieces before putting them in the measuring
jug.
4. Always put liquid in the mixing jug before adding solid ingredients.
5. Never fill the mixing jug with hot liquid above 60°C.
6. You can use the opening in the mixing jug lid to add ingredients to your mixture. Do not
attempt to put your hand through the opening. Make sure the ingredients don't splash out
when you remove the cap from the opening; switch to a low speed if necessary. After
adding the ingredients through the feed opening, replace the cap (as described previously).
7. When turning off the blender, make sure the mixing blade (part no.4) has stopped moving
before you attempt to remove the mixing jug from the base unit. You could damage the
plastic/rubber clutch mechanism if you don't wait for everything to stop.
8. Certain hard spices, such as cloves, caraway seed and dill seed, may damage the plastic
parts of the mixing jug. We recommend that you avoid using these in the blender. Other
foods, such as carrots, include natural dyes that may permanently colour the plastic parts of
the blender. This discolouration will not affect the efficiency of the appliance.
9. Avoid 'over-blending' your ingredients. You may find it useful to occasionally stop and
check the consistency of your mixture.
10. Avoid continuous operation or frequent, repeated operations - particularly when using
relatively solid ingredients or smaller quantities.
MAINTENANCE AND CLEANING
1. You must clean the appliance after every use, taking particular care to clean the mixing jug
and mixing blade. Unplug the blender from the mains, then detach the jug from the base
unit. Remove food residue by rinsing the jug under running water. Now fill the mixing jug
up to the 0.75l mark with warm water (maximum 60°C) and a small amount of mild
detergent. Return the jug to the base unit, connect the base to the mains and hold the
„Auto Clean” switch for about 30 seconds. Finally disconnect the base, remove the jug and
rinse the jug under running water until it's clean.
PB-460
EN
11
User'sManual for PB-460_User's Manual for PB-460 2016.08.02. 19:02 Page 11