Dynojet sd12, Руководство по установке

Страница: 47 / 50

A-3
R E S E T B E A R I N G S E T S C R E W S
Reset the Bearing Set Screws
Version 2 Model SD12 Scooter Dynamometer Installation Guide
L
OOSENING THE
B
RAKE
S
PRING
E
YEBOLT
1 Using the access hole in the drum assembly, mark the location of the brake
actuator spring eyebolt.
2 Loosen the brake actuator spring eyebolt until totally slack. This will allow the
drum to spin.
Note: Ramp and front support not shown for clarity. Drum assembly covers
shown transparent to show internal components.
Figure A-2: Loosen the Brake Spring Eyebolt
A
CCESSING THE
B
OTTOM OF THE
D
RUM
M
ODULE
1 Lock the front support and ramp into the upright position.
2 Tip the dyno forward until the front support rests on the floor. This will expose the
bottom of the drum module.
Figure A-3: /Access the Bottom of the Drum Module
SD026
eyebolt
access hole
SD037