background image

2009 Yamaha FZ1  PCV - 

1

22-015  www.powercommander.com

2191 Mendenhall Drive   North Las Vegas, NV 89081   (800) 992-4993   www.powercommander.com

2009 Yamaha FZ1

Installation Instructions

Parts List

Power Commander

USB Cable

CD-ROM

Installation Guide

Power Commander Decals

2  

Dynojet Decals

Velcro

®

 Strip

Alcohol Swab

O2 optimizer

YOU CAN ALSO DOWNLOAD THE  

POWER COMMANDER SOFTWARE AND  

LATEST MAPS FROM OUR WEB SITE AT:

WWW.POWERCOMMANDER.COM

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

The ignition MUST be turned 

OFF before installation!

Содержание 2009 Yamaha FZ1

Страница 1: ... Parts List 1 Power Commander 1 USB Cable 1 CD ROM 1 Installation Guide 2 Power Commander Decals 2 Dynojet Decals 2 Velcro Strip 1 Alcohol Swab 1 O2 optimizer YOU CAN ALSO DOWNLOAD THE POWER COMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEB SITE AT WWW POWERCOMMANDER COM PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION The ignition MUST be turned OFF before installation ...

Страница 2: ... gear position is setup you can alter your map based on gear position and setup gear dependent kill times when using a quickshifter Analog This input is for a 0 5v signal such as engine temp boost etc Once this input is established you can alter your fuel curve based on this input in the control center software Crank Do NOT connect anything to this port unless instructed to do so by Dynojet It is ...

Страница 3: ...tion and go towards the front of the bike 4 Locate the connector from the main wiring harness to the injector rail and uplug this connector Fig A NOTE This connector is grey in color 5 Plug the connectors from the PCV in line of the stock wiring harness Fig B 6 Remove the bolt on the left hand side of thefuel tank bracket and loosen the right hand bolt enough to route the PCV harness under neath i...

Страница 4: ...Fig E 10 Plug the Dynojet O2 optimizer into the main wiring harness The stock O2 sensor will not be connected to anything anymore FIG F 11 Install the PCV in the rear section of the trunk Fig F 12 Make sure all the wires are routed properly 13 Reinstall the main seat and the passenger seat Speed input Pink wire on white 3 pin connector under fuel tank Temperature input Green White wire same plug a...

Отзывы: