Dynisco IPX II Series, Руководство по эксплуатации

Страница: 61 / 78

61
COMMISSIONING
To confirm the resetting of the trim press the ENTER ENTER ENTER ENTER ENTER key. After the trim has been reset the display
will return to:
Press the NEXT NEXT NEXT NEXT NEXT key to proceed to the next menu selection, OFFS OFFS OFFS OFFS OFFSET ET ET ET ET.
7.2.2 7.2.2
7.2.2 7.2.2
7.2.2
P P
P P P
O O
O O
O
FFSET FFSET
FFSET FFSET FFSET
The next function of the IPX II Series Smart Pressure Transmitter is OFFS OFFS OFFS OFFS OFFSET ET ET ET ET. This function provides an
additional offset to the display. The display will sequence as follows:
If an additional offset is not needed press the NEXT NEXT NEXT NEXT NEXT key to move onto the next function. To add an
additional offset press the ENTER ENTER
ENTER ENTER
ENTER key. To toggle through the offset options press the NEXT NEXT
NEXT NEXT
NEXT key. They
are listed below:
After determining whether the OFFS
OFFS
OFFS OFFS OFFSET
ET
ET ET ET, is to be added to (PLUS ?) or subtracted from (MINUS ?),
press the ENTER ENTER ENTER ENTER ENTER key. The leftmost digit position will start blinking (shown in italics). Press the NEXT NEXT NEXT NEXT NEXT
key to increment through 1 2 3 4 5 6 7 8 9 0. When the desired numeral is reached, press the
ENTER
ENTER
ENTER ENTER
ENTER key to accept the selection.
The second digit from the left will start blinking. As before, change the number in this digit position
by continuously pressing the NEXT
NEXT NEXT NEXT NEXT key until the desired numeral is reached. Then press the ENTER ENTER ENTER ENTER ENTER
key to move to the next lower significant digit position. Each time the NEXT NEXT NEXT NEXT NEXT key will cycle through