Dynisco IPX II Series, Руководство по эксплуатации

Страница: 46 / 78

46
COMMISSIONING
7 7 7 7 7.2.2 .2.2 .2.2 .2.2 .2.2
C C
C C C
S S S S S
ELE ELE
ELE ELE ELECT
CT
CT CT CT
D D D D D
IS IS
IS IS ISPLA
PLA
PLA PLA PLAY
Y
Y Y Y
S S S S S
T TT
TTA
A
A A ATUS
TUS
TUS TUS TUS
Press the ENTER ENTER ENTER ENTER ENTER key. This will allow you to set-up the transmitter using the Operate Mode. A flow
chart summarizing the operation is in section 7.2.3.
The DIS
DIS
DIS DIS DISPLA
PLA
PLA PLA PLAY
Y
Y Y Y S
S
S S ST
TT
TTA
A
A A ATUS
TUS
TUS TUS TUS is the first function in the sequence. The display will read as follows to
indicate this position on the menu:
Press the ENTER
ENTER
ENTER ENTER ENTER key to see the current set-up of the IPX II Series Smart Pressure Transmitter. Use the
NEXT NEXT NEXT NEXT NEXT key to continue onto the next function.
7.2.2 7.2.2 7.2.2 7.2.2 7.2.2
D D
D D D
S S S S S
ENSOR ENSOR
ENSOR ENSOR ENSOR
U U U U U
NITS NITS
NITS NITS NITS
The S S S S SELE ELE ELE ELE ELECT PRE CT PRE CT PRE CT PRE CT PRES S S S SSURE SURE SURE SURE SURE UNIT UNIT UNIT UNIT UNITS S S S S is the next function in the sequence. The display will sequence as
follows:
The factory set default is P P P P PSI SI SI SI SI. If the factory set default is the required pressure unit press the NEXT NEXT NEXT NEXT NEXT
key to move onto the next function. If a change is required, press the ENTER ENTER ENTER ENTER ENTER key to go into the list
of pressure units. Use the NEXT NEXT
NEXT NEXT
NEXT key to sequence through the selectable pressure units. One can stop
at any one of the pressure selections by pressing the ENTER
ENTER
ENTER ENTER ENTER key, this changes the IPX II to the
required units of pressure. The list of pressure units is listed below:
(Pounds per square inch)
Press the NEXT NEXT NEXT NEXT NEXT key to go to the next unit (continue to do this until the desired pressure unit is listed
and then press ENTER ENTER ENTER ENTER ENTER).
(Bar)