INSTRUCTIONS: QUASAR SV Code: DYN 64.1.06
Date: 08/11/2016 Revision: 06
1
1 GENERAL INSTRUCTIONS
DYNATECH’s QUASAR SV overspeed governor was specially designed to be fitted in the lift’s car or frame and
move along with them.
The governor moves along the hoist way
whereas the rope remains fixed attached to the shaft and pit’s ceiling via a
tensioning system. The information about the devices making up the Governor will be extended further on.
The Quasar SV governor is a governor with reduced dimensions (120 mm pulley diameter). It was designed so as to
save space.
It is strictly forbidden:
a) To modify or replace the overspeed governor adjustment spring.
b) Use an overspeed governor in a lift for which it is not intended, or whose features do not correspond to those
marked on the lift (e.g. nominal speed or rope type).
c) To adjust any component of the overspeed governor, except for those parts specified in the manual.
DYNATECH DYNAMICS & TECHNOLOGY, SL will not be liable for any damage caused by failure to observe any of
these general conditions.
2 OVERSPEED GOVERNOR IDENTIFICATION
3 MAIN COMPONENTS OF THE GOVERNOR
The overspeed governor is made up of the following main elements: One main pulley with centrifugal system, one
diverter pulley, a centrifugal system, a locking part and a component linking the governor to the car or frame.
A picture displaying the governor as a whole can be seen below:
OVERSPEED GOVERNOR IDENTIFICATION LABEL
1
Governor model
6
Rope diameter (mm)
2
Governor type
7
QR product traceability code
3
Performance speed
(m/s)
8
Dynatech address
4
Rated speed (m/s)
9
Quality assurance CE marking
and notified body number
5
Serial number
10
EU type examination certificate
number
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/
Содержание QUASAR-SV
Страница 2: ......
